LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Disc Brake Assembly >> Disassembly

Rear Disc Brake Assembly: Disassembly

  1. Remove the boot ring.
    Fig 1: Removing Boot Ring
    G03751816Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the piston boot.
    Fig 2: Removing Piston Boot
    G03751817Courtesy of SUBARU OF AMERICA, INC.
  3. Gradually supply compressed air via inlet of caliper body to force piston out.
    CAUTION:
    • Place a wooden block as shown in Fig 3 to prevent damage to piston.
    • Do not apply excessively high-pressure.
    Fig 3: Supplying Compressed Air Via Inlet Of Caliper Body For Removing Piston
    G03751818Courtesy of SUBARU OF AMERICA, INC.
  4. Remove piston seal from caliper body cylinder.
    Fig 4: Removing Piston Seal From Caliper Body Cylinder
    G03751819Courtesy of SUBARU OF AMERICA, INC.
  5. Remove lock pin sleeve and boot from caliper body.
  6. Remove guide pin boot.
scientia non olet · About LEMON Manuals