LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Brake Pad >> Installation

Rear Brake Pad: Installation

  1. Apply thin coat of Molykote AS880N (Part No. 26298AC000) to the frictional portion between pad and pad clip.
    CAUTION: Do not allow oil or grease to adhere to the sliding surface of pad and disc rotor.
  2. Check disc rotor thickness and runout.

    < Ref. to , INSPECTION , Rear Disc Rotor. >

  3. Install pad on support.
  4. Install caliper body on support.

    Tightening torque: 

    39 N.m (4.0 kgf-m, 28.9 ft-lb) 

    NOTE: If it is difficult to push piston during pad replacement, loosen air bleeder to facilitate work.
  5. Depress brake pedal several times.
  6. Check that brake fluid level is at max. line.
scientia non olet · About LEMON Manuals