Brake Pedal: Assembly

Attach stop light switch, etc. to pedal bracket temporarily.
Clean inside of bores of clutch pedal and brake pedal, apply grease, and set bushings into bores.
Align bores of pedal bracket, clutch pedal and brake pedal, attach brake pedal return spring and clutch pedal effort reducing spring (vehicle with hill holder), and then install pedal bolt.
NOTE: Clean up inside of bushings and apply grease before installing spacer.

Tightening torque:

T:29 N.m (3.0 kgf-m, 21.7 ft-lb)

Fig 1: Installing Pedal Bolt
Courtesy of SUBARU OF AMERICA, INC.
Set brake pedal position by adjusting position of stop light switch.
Pedal position: L

126.4 mm (4.98 in)

Tightening torque:

T: 8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 2: Setting Brake Pedal Position By Adjusting Position Of Stop Light Switch
Courtesy of SUBARU OF AMERICA, INC.