SUBARU Select Monitor (OBD Mode)

WARNING: This page is about a different variant/trim than selected.

On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
On the "System Selection Menu" display screen, select the {Engine} and press the [YES] key.
Press the [YES] key after the information of engine type has been displayed.
On the "Engine Diagnosis" display screen, select the {OBD System} and press the [YES] key.
On the "OBD Menu" display screen, select the {DTC Display} and press the [YES] key.
Make sure DTC is shown on the screen.

NOTE:

For detailed operation procedure, refer to " SUBARU SELECT MONITOR OPERATION MANUAL ".
For details concerning DTC, refer to LIST OF DIAGNOSTIC TROUBLE CODE DTC .