SUBARU Select Monitor (Normal Mode)

WARNING: This page is about a different variant/trim than selected.

On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
On the "System Selection Menu" display screen, select the {Engine} and press the [YES] key.
Press the [YES] key after the information of engine type has been displayed.
On the "Engine Diagnosis" screen, select the {DTC Display}, and then press the [YES] key.
On the "Diagnostic Code(s) Display" screen, select the {Current Diagnostic Code(s)} or {History Diagnostic Code(s)}, and then press the [YES] key.

NOTE:

For detailed operation procedure, refer to " SUBARU SELECT MONITOR OPERATION MANUAL ".
For details concerning DTC, refer to LIST OF DIAGNOSTIC TROUBLE CODE DTC .