Rear Exhaust Pipe: Installation

WARNING: This page is about a different variant/trim than selected.

Apply a coat of spray type lubricant to the mating area of cushion rubber.
Install the rear exhaust pipe bracket to cushion rubber.

Fig 1: Installing Rear Exhaust Pipe Bracket To Cushion Rubber
Courtesy of SUBARU OF AMERICA, INC.
Install the rear exhaust pipe to muffler.
NOTE: Use a new gasket and self-locking nut.

Tightening torque:

48 N.m (4.9 kgf-m, 35.4 ft-lb)
- LH side
  
  Fig 2: Installing Self-Locking Nut (LH Side)
  Courtesy of SUBARU OF AMERICA, INC.
- RH side
Fig 3: Installing Self-Locking Nut (RH Side)
Courtesy of SUBARU OF AMERICA, INC.
Install the rear exhaust pipe to center exhaust pipe.
Tightening torque:

18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 4: Installing Rear Exhaust Pipe To Center Exhaust Pipe
Courtesy of SUBARU OF AMERICA, INC.