LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Intake (Induction) (H4SO)) >> Air Cleaner Element >> Removal

Air Cleaner Element: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G03827861Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the connector from mass air flow and intake air temperature sensor.
    Fig 2: Disconnecting Mass Air Flow And Intake Air Temperature Sensor Connector
    G03827862Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the clip (A) from upper side of air cleaner case.
    Fig 3: Removing Clip From Upper Side Of Air Cleaner Case
    G03827863Courtesy of SUBARU OF AMERICA, INC.
  4. Pull the air cleaner case (rear) to rearward of the vehicle, and then remove the air cleaner element.
NOTE: Be careful that the power steering hose is secured to the under side of air cleaner case (rear).