LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Clutch System) >> Clutch Pedal >> Assembly

Clutch Pedal: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Temporarily assemble the clutch switch, etc. to pedal bracket.
  2. Clean the inside of bores of clutch pedal and brake pedal, and apply grease, and set bushings into bores.
  3. Align the bores of pedal bracket, clutch pedal and brake pedal, and then attach the brake pedal return spring, assist rods, spring and bushing.
NOTE: Clean up the inside of bushings and apply grease before installing spacer.
scientia non olet · About LEMON Manuals