LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Manual Transmission And Differential (5MT)) >> Switches and Harness >> Inspection >> Neutral Position Switch

Neutral Position Switch

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector of neutral position switch.
  3. Measure the resistance between neutral position switch terminals.
    • Non-turbo model
      Fig 1: Measuring Resistance Between Neutral Position Switch Terminals - Non-Turbo Model
      G03832035Courtesy of SUBARU OF AMERICA, INC.
      GEAR SHIFT POSITION, TERMINAL NO AND SPECIFIED RESISTANCE

      Gear shift position Terminal No. Specified resistance
      Neutral position 1 and 2 More than 1 M
      Other positions Less than 1
    • Turbo model
    Fig 2: Measuring Resistance Between Neutral Position Switch Terminals - Turbo Model
    G03832036Courtesy of SUBARU OF AMERICA, INC.
    GEAR SHIFT POSITION, TERMINAL NO AND SPECIFIED RESISTANCE

    Gear shift position Terminal No. Specified resistance
    Neutral position 1 and 3 More than 1 M
    Other positions Less than 1
  4. Replace the faulty parts.
scientia non olet · About LEMON Manuals