Main Shaft Assembly for Single-Range: Adjustment
WARNING: This page is about a different variant/trim than selected.
Selection of main shaft rear plate: Using the ST, measure the amount (A) of ball bearing protrusion from transmission main case surface, and select a suitable plate from the table shown in DIMENSION (A) MM (IN), PART NUMBER AND MARKING CHART .
NOTE:
Before measuring, tap the end of main shaft with a plastic hammer lightly in order to make the clearance zero between the main case surface and moving flange of bearing.
ST 498147000 DEPTH GAUGE
DIMENSION (A) MM (IN), PART NUMBER AND MARKING CHART
| Dimension (A) mm (in) | Part Number | Marking |
|---|---|---|
| 4.00 - 4.13 (0.1575 - 0.1626) | 32294AA041 | 1 |
| 3.87 - 3.99 (0.1524 - 0.1571) | 32294AA051 | 2 |