Transmission Case Assembly
WARNING: This page is about a different variant/trim than selected.
Drive pinion shim adjustment
Hypoid gear backlash:
0.13 - 0.18 mm (0.0051 - 0.0071 in)
DRIVE PINION SHIM PART NUMBER AND THICKNESS MM CHART
| Drive pinion shim | |||
|---|---|---|---|
| Part Number | Thickness mm (in) | Part Number | Thickness mm (in) |
| 32295AA031 | 0.150 (0.0059) | 32295AA071 | 0.250 (0.0098) |
| 32295AA041 | 0.175 (0.0069) | 32295AA081 | 0.275 (0.0108) |
| 32295AA051 | 0.200 (0.0079) | 32295AA091 | 0.300 (0.0118) |
| 32295AA061 | 0.225 (0.0089) | 32295AA101 | 0.500 (0.0197) |
Selection of main shaft rear plate
MAIN SHAFT REAR PLATE SPECIFICATION
| Main shaft rear plate | ||
|---|---|---|
| Dimension "A" mm (in) | Part Number | Marking |
| 4.00 - 4.13 (0.1575 - 0.1626) | 32294AA041 | 1 |
| 3.87 - 3.99 (0.1524 - 0.1571) | 32294AA051 | 2 |