DTC P0741 Torque Converter Clutch Circuit Performance Or Stuck Off

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION:

Lock up clutch malfunction
Locking of bulb

TROUBLE SYMPTOM:

No lock-up occurs.

DTC P0741 DIAGNOSTIC PROCEDURE

Step	CHECK	Yes	No
1 CHECK LOCK-UP DUTY SOLENOID CIRCUIT. Diagnose according to DTC P0743 procedure.	Is there any trouble?	Repair or replace the lock-up duty solenoid circuit.	Go to step 2 .
2 CHECK INHIBITOR SWITCH CIRCUIT. Diagnose according to DTC P0705 procedure.	Is there any trouble?	Repair or replace the inhibitor switch circuit.	Go to step 3 .
3 CHECK STOP LIGHT SWITCH CIRCUIT. Diagnose according to DTC P0719 and P0724 procedure.	Is there any trouble?	Repair or replace the stop light switch circuit.	Go to step 4 .
4 CHECK ATF TEMPERATURE SENSOR CIRCUIT. Diagnose according to DTC P0712 and P0713 procedure.	Is there any trouble?	Repair or replace the ATF temperature sensor circuit.	Go to step 5 .
5 CHECK ACCELERATOR PEDAL POSITION SENSOR. Connect the Subaru Select Monitor to data link connector. Turn the ignition switch to ON. Read the value of "Accel, opening angle" on Subaru Select Monitor display.	Does the value of accelerator pedal position sensor change from 0% to 100% smoothly when throttle was operated from fully closing to fully opening?	Go to step 6 .	Check the accelerator pedal position sensor circuit.
6 CHECK TORQUE CONVERTER TURBINE SPEED SENSOR. Shift the select lever to "P" or "N" range. Idle the engine.	Does the turbine revolution displayed by Subaru Select Monitor almost correspond with engine revolution indicated by tachometer?	Go to step 7 .	Check the torque converter turbine speed sensor circuit.
7 CHECK ENGINE SPEED SIGNAL. Idle the engine.	Does the turbine revolution displayed by Subaru Select Monitor almost correspond with engine revolution indicated by tachometer?	There is transmission assembly mechanical malfunction.	Check the engine speed signal circuit.