LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission (Diagnostics) 4AT (D)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0736 Reverse Incorrect Ratio

DTC P0736 Reverse Incorrect Ratio

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION: 

Vehicle sensor, torque converter turbine speed sensor or control valve malfunction

TROUBLE SYMPTOM: 

DTC P0736 DIAGNOSTIC PROCEDURE

Step CHECK Yes No

CHECK ACCELERATOR PEDAL POSITION SENSOR. 
  1. Connect the Subaru Select Monitor to data link connector.
  2. Turn the ignition switch to ON.
  3. Read the value of "Accel, opening angle" on Subaru Select Monitor display.
Does the value of accelerator pedal position sensor change from 0% to 100% smoothly when throttle was operated from fully closing to fully opening? Go to step . Check the accelerator position sensor circuit. < Ref. to , DTC P1708 THROTTLE POSITION SENSOR CIRCUIT LOW INPUT , Diagnostic Procedure with Diagnostic Trouble Code (DTC). >

CHECK FRONT VEHICLE SPEED SENSOR. 
  1. Lift-up the vehicle and support with rigid racks.
  2. Start the engine.
  3. Shift the select lever to "D" range and slowly increase vehicle speed.
NOTE: The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunction. When AT control diagnosis is finished, perform the ABS memory clearance procedure of on-board diagnostics system. < Ref. to CLEAR MEMORY MODE . >
Does the vehicle speed displayed by Subaru Select Monitor almost correspond with vehicle speed indicated by combination meter? Go to step 3.  Check the front vehicle speed sensor circuit.

CHECK TORQUE CONVERTER TURBINE SPEED SENSOR. 
  1. Shift the select lever to "P" or "N" range.
  2. Idle the engine.
Does the turbine speed sensor revolution displayed by Subaru Select Monitor almost correspond with engine revolution indicated by tachometer? There are malfunctions in TCM, TCM connector poor contact, or transmission assembly mechanical malfunction. Check the torque converter turbine speed sensor circuit.