LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls - Engine (Diagnostics) (H4DOTC)) >> Drive Cycle >> Operation >> Preparation For The Drive Cycle

Preparation For The Drive Cycle

WARNING: This page is about a different variant/trim than selected.
  1. Make sure that the fuel remains approx. half amount [20 - 40 Lambda (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)], and battery voltage is 12 V or more.
  2. After clearing the memory, check for any remaining trouble data unresolved. < Ref. to , CLEAR MEMORY MODE . >
  3. Separate the test mode connector.
NOTE:
  • Except for the engine coolant temperature specified items at starting, the diagnosis is carried out after engine warm up.
  • Carry out the diagnosis which is marked * on DTC twice, then, after finishing first diagnosis, stop the engine and do second time at the same condition.
scientia non olet · About LEMON Manuals