LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Lubrication (H4DOTC)) >> Oil Pressure System >> Inspection

Oil Pressure System: Inspection

WARNING: This page is about a different variant/trim than selected.
OIL PRESSURE SYSTEM INSPECTION

Step Check Yes No
1. CHECK COMBINATION METER. 
  1. Turn the ignition switch to ON (engine OFF).
  2. Check the warning light of combination meter.
 Does the warning light illuminate? Go to step 2.  Repair or replace the combination meter. < Ref. to INSPECTION , Combination Meter System. >
2. CHECK HARNESS CONNECTOR BETWEEN COMBINATION METER AND OIL PRESSURE SWITCH. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector from oil pressure switch.
  3. Turn the ignition switch to ON.
  4. Measure the voltage of harness between combination meter connector and chassis ground.

    Connector & terminal 

    (El1) No. 1 (+) - Chassis ground (-): 

 Is the voltage more than 10 V? Replace the oil pressure switch. Go to step 3. 
3. CHECK COMBINATION METER. 
  1. Turn the ignition switch to OFF.
  2. Remove the combination meter.
  3. Measure the resistance of combination meter.

    Terminals 

    (i10) No. 4 - (i10) No. 15: 

    (i10) No. 3 - (i10) No. 15: 

 Is the resistance less than 10 Ω? Replace the harness connector between combination meter and oil pressure switch. Repair or replace the combination meter. < Ref. to INSPECTION , Combination Meter System. >
scientia non olet · About LEMON Manuals