Special Tool
WARNING: This page is about a different variant/trim than selected.
- Be careful not to burn yourself, because each part on the vehicle is hot after running.
- Be sure to tighten fasteners including bolts and nuts to the specified torque.
- Place shop jacks or rigid racks at the specified points.
- Before disconnecting electrical connectors of sensors or units, be sure to disconnect the ground cable from battery.
SPECIAL TOOL DESCRIPTION
| ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
|---|---|---|---|
| Fig 1 | 499977100 | CRANK PULLEY WRENCH | Used for stopping rotation of crank pulley when removing and tightening crank pulley bolt. |
| Fig 2 | 499587100 | OIL SEAL INSTALLER | Used for installing oil seal into oil pump. |
| Fig 3 | 18332AA000 | OIL FILTER WRENCH | Used for removing and installing oil filter. (Outer diameter: 68 mm (2.68 in)) |
| Fig 4 | 18332AA010 | OIL FILTER WRENCH | Used for removing and installing oil filter. (Outer diameter: 65 mm (2.56 in)) |