Intake And Exhaust Valve
WARNING: This page is about a different variant/trim than selected.
- Inspect the flange and stem of valve, and replace them if damaged, worn, deformed or if "H" is exceed the standard value or if they have partial wear.
H:
Standard (Intake)
1.0 - 1.4 mm (0.039 - 0.055 in)
Standard (Exhaust)
1.3 - 1.7 mm (0.051 - 0.067 in)
Valve overall length:
Intake
104.4 mm (4.110 in)
Exhaust
104.65 mm (4.1201 in)
- Put a small amount of grinding compound on the seat surface, and lap the valve and seat surface. Install a new intake valve oil seal after lapping.