LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls - Engine (Diagnostics) (H4SO U5 (PZEV))) >> Read Diagnostic Trouble Code (DTC) >> Operation >> SUBARU Select Monitor (OBD Mode)

SUBARU Select Monitor (OBD Mode)

WARNING: This page is about a different variant/trim than selected.
  1. On the << Main Menu>> display screen, select the {Each System Check} and press the [YES] key.
  2. On the << System Selection Menu>> display screen, select the {Engine} and press the [YES] key.
  3. Press the [YES] key after the information of engine type has been displayed.
  4. On the << Engine Diagnosis>> display screen, select the {OBD System} and press the [YES] key.
  5. On the << OBD Menu>> display screen, select the {DTC Display} and press the [YES] key.
  6. Make sure DTC is shown on the screen.
NOTE:
  • For detailed operation procedure, refer to " SUBARU SELECT MONITOR OPERATION MANUAL ".
  • For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)". < Ref. to , LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >
scientia non olet · About LEMON Manuals