Fuel Sub Level Sensor: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.

NOTE: Use a new gasket.

Ensure the sealing portion is free from fuel or foreign particles before installation.
Tighten the nuts and bolts to specified torque in the order as shown in Fig 1 .
Tightening torque:

4.4 N.m (0.45 kgf-m, 3.2 ft-lb)

Fig 1: Tightening Bolts With Torque Specification (1 Of 2)
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Tightening Bolts With Torque Specification (2 Of 2)
Courtesy of SUBARU OF AMERICA, INC.