Fuel Pump: Removal

WARNING: This page is about a different variant/trim than selected.

WARNING:

NOTE: Fuel pump assembly consists of fuel pump and fuel level sensor.

Release the fuel pressure.
< Ref. to , RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel. >
Drain the fuel. < Ref. to , DRAINING FUEL , PROCEDURE, Fuel. >
Remove the rear seat.
Remove the service hole cover.

Fig 1: Removing Service Hole Cover
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from fuel pump.

Fig 2: Disconnecting Connector From Fuel Pump
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the quick connector and then disconnect the fuel delivery hose, return hose and jet pump hose. < Ref. to , REMOVAL , Fuel Delivery, Return and Evaporation Lines. >
Remove the nuts which install the fuel pump assembly onto fuel tank.

Fig 3: Removing Nuts Of Fuel Pump Assembly Onto Fuel Tank
Courtesy of SUBARU OF AMERICA, INC.
Take off the fuel pump assembly from fuel tank.