Rear Exhaust Pipe: Installation

1. Apply a coat of spray type lubricant to the mating area of cushion rubber.
2. Install the rear exhaust pipe bracket to cushion rubber.
   Fig 1: Installing Rear Exhaust Pipe Bracket To Cushion Rubber

   Courtesy of SUBARU OF AMERICA, INC.
3. Install the rear exhaust pipe to muffler.
   NOTE: Use a new gasket and self-locking nut.

   Tightening torque: 

   48 N.m (4.9 kgf-m, 35.4 ft-lb) 

   • LH side
     Fig 2: Installing Rear Exhaust Pipe To Muffler (LH)

     Courtesy of SUBARU OF AMERICA, INC.
   • RH side
Fig 3: Installing Rear Exhaust Pipe To Muffler (RH)
Courtesy of SUBARU OF AMERICA, INC.
4. Install the rear exhaust pipe to center exhaust pipe.

Tightening torque: 

18 N.m (1.8 kgf-m, 13.0 ft-lb) 

Fig 4: Installing Rear Exhaust Pipe To Center Exhaust Pipe Nut

Courtesy of SUBARU OF AMERICA, INC.