LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Forester XT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Master Cylinder >> Assembly

Master Cylinder: Assembly

  1. Apply recommended brake fluid to the inside wall of cylinder, and to outer surface of the piston assembly.
  2. Ensure that the inside wall of cylinder, and piston assembly are free from dirt when assembling. Install the primary piston assembly and secondary piston assembly, while taking care not to damage, scratch, or dent the cylinder inside wall, and piston assembly.
  3. Install the cylinder pin while pushing in primary piston by screwdriver which wrapped with tape.
  4. Install the C-ring. (With VDC)
    Fig 1: Installing C-Ring. (With VDC)
    G03808681Courtesy of SUBARU OF AMERICA, INC.
  5. Install the piston retainer, and then secure it by pressing the pawl.
    Fig 2: Pressing Pawl
    G03808682Courtesy of SUBARU OF AMERICA, INC.
  6. Install the seal to reservoir tank.
    Fig 3: Installing Seal To Reservoir Tank
    G03808683Courtesy of SUBARU OF AMERICA, INC.
  7. Install the reservoir tank to master cylinder and secure with pin.
scientia non olet · About LEMON Manuals