LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Forester XS, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Disc Brake Assembly >> Installation

Rear Disc Brake Assembly: Installation

  1. Install the disc rotor on hub.
  2. Install the support on housing.

    Tightening torque: 

    52 N.m (5.3 kgf-m, 38.3 ft-lb) 

  3. Apply thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
  4. Install the pads on support.
  5. Install the caliper body on support.

    Tightening torque: 

    37 N.m (3.8 kgf-m, 27.5 ft-lb) 

  6. Replace the brake hose gaskets with new ones, and then connect the brake hose.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

    CAUTION: The brake hose must be connected without any twist.
  7. Bleed air from the brake system. < Ref. to AIR BLEEDING . >
scientia non olet · About LEMON Manuals