Rear Brake Hose (Disc Brake)
- Pass the brake hose through hole of bracket, and lightly tighten the flare nut to connect brake pipe.
- Insert the clamp upward to fix brake hose.
- Install the brake hose to caliper using a new gasket.
Tightening torque (Union bolt):
18 N.m (1.8 kgf-m, 13.0 ft-lb)
- While holding the hexagonal part of brake hose fitting with a wrench, tighten the flare nut to the specified torque.
Tightening torque (Brake pipe flare nut):
15 N.m (1.5 kgf-m, 10.8 ft-lb)
- Bleed air from the brake system.