LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Forester X, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Disc Brake Assembly >> Disassembly

Rear Disc Brake Assembly: Disassembly

  1. Remove the boot ring.
    Fig 1: Removing Boot Ring
    G03808650Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the piston boot.
    Fig 2: Removing Piston Boot
    G03808651Courtesy of SUBARU OF AMERICA, INC.
  3. Place a wooden block as shown in the figure to prevent damage to the piston. Gradually supply compressed air via inlet of the brake hose to force piston out.
    Fig 3: Supplying Compressed Air Via Inlet Of Brake Hose To Force Piston Out
    G03808652Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the piston seal from caliper body cylinder.
    CAUTION: Be careful not to scratch the inner surface of cylinder and piston seal groove.
    Fig 4: Removing Piston Seal From Caliper Body Cylinder
    G03808653Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the lock pin sleeve and pin boot from caliper body.
  6. Remove the guide pin (green) and pin boot.
scientia non olet · About LEMON Manuals