LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Forester X, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Hill Holder >> Installation >> PHV (Pressure Hold Valve)

PHV (Pressure Hold Valve)

  1. Install the PHV onto side frame.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

  2. Connect the brake pipes to PHV.

    Tightening torque: 

    15 N.m (1.5 kgf-m, 10.8 ft-lb) 

    CAUTION: Confirm that the brake pipes are not deformed and/or damaged. Replace them with new ones if necessary.
  3. Install the PHV cable to PHV.
    CAUTION:
    • If the cable clamp (and clips) is damaged, replace it with a new one.
    • Avoid sharp bending of PHV cable as it may cause breakage.
  4. Connect the PHV cable with clips.
  5. Apply grease to the following points.
    • Hook portion of return spring
    • Cable end portion of lever

    Grease: SUNLIGHT 2 (Part No. 003602010) 

  6. Be sure to bleed air from the brake system. < Ref. to AIR BLEEDING . >
  7. Adjust the PHV cable. < Ref. to PHV CABLE , Installation, Hill Holders
CAUTION: After replacing the PHV cable with new one, operate the clutch pedal about 30 times as a running-in operation prior to adjustment.
scientia non olet · About LEMON Manuals