Front Brake Pad: Installation

Apply thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
Apply thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between inner pad and rubber coated shim.
NOTE:
- Do not apply grease between outer pad and outer shim.
- Do not confuse the inner shim with outer shim.
CAUTION: Replace the pad if there is oil or grease on it.

Fig 1: Caution For Brake Pad (Not Apply Grease Between Outer Pad And Outer Shim)
Courtesy of SUBARU OF AMERICA, INC.
Install the pads on support.
Install the caliper body on support.

Tightening torque:

37 N.m (3.8 kgf-m, 27.5 ft-lb)

NOTE: If it is difficult to push the piston during pad replacement, loosen the air bleeder to facilitate work.