LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Forester X, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Brake Pedal >> Assembly

Brake Pedal: Assembly

  1. Attach the stop light switch, etc. to pedal bracket temporarily.
  2. Clean the inside of bores of clutch pedal and brake pedal, apply grease, and set the bushings into bores.
  3. Align bores of the pedal bracket, clutch pedal and brake pedal, attach the brake pedal return spring and clutch pedal effort reducing spring (vehicle with hill holder), and then install the pedal bolt.
    NOTE: Clean up the inside of bushings and apply grease before installing spacer.

    Tightening torque: 

    T: 29 N.m (3.0 kgf-m, 21.7 ft-lb) 

    Fig 1: Identifying Pedal Bolt Tightening Torque
    G03808718Courtesy of SUBARU OF AMERICA, INC.
  4. After installing the brake pedal to vehicle, adjust the stop light position. < Ref. to ADJUSTMENT , Stop Light Switch. >
scientia non olet · About LEMON Manuals