Stop Light Switch: Inspection

If stop light switch does not operate properly (or if it does not stop at the specified position), replace with a new one.
Specified position: L

2 ^+1.5/0 mm (0.079 ^+0.059/0 in)

Fig 1: Identifying Stop Light Switch Specified Position
Courtesy of SUBARU OF AMERICA, INC.
Measure the clearance between threaded end of stop light switch and stopper.
CAUTION: Be careful not to rotate stop light switch.

Stop light switch clearance: A

0.3 mm (0.012 in)

Fig 2: Identifying Clearance Between Threaded End Of Stop Light Switch And Stopper
Courtesy of SUBARU OF AMERICA, INC.
If it is not in specified value, adjust it by adjusting position of stop light switch.
CAUTION: Be careful not to rotate stop light switch.