LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Disc Brake Assembly >> Installation

Rear Disc Brake Assembly: Installation

  1. Install disc rotor on hub.
  2. Install support on back plate.

    Tightening torque: 

    78 N.m (8.0 kgf-m, 58 ft-lb) 

    CAUTION:
    • Always replace the pads for both the left and right wheels at the same time. Also replace pad clips if they are twisted or worn.
    • A wear indicator is provided on the inner disc brake pad. If the pad wears down to such an extent that the end of the wear indicator contacts the disc rotor, a squeaking sound is produced as the wheel rotates. If this sound is heard, replace the pad.
    • Replace pads if there is oil or grease on them.
  3. Apply thin coat of Molykote AS880N (Part No. 26298AC000) to the frictional portion between pad and pad clip.
    CAUTION: Do not allow oil or grease to adhere to the sliding surface of pad and disc rotor.
  4. Install pads on support.
  5. Install caliper body on support.

    Tightening torque: 

    39 N.m (4.0 kgf-m, 28.9 ft-lb) 

  6. Connect brake hose.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

    CAUTION:
    • The brake hose must be connected without any twist.
    • Replace brake hose gaskets with new ones.
  7. Bleed air from brake system.

    < Ref. to , AIR BLEEDING . >

scientia non olet · About LEMON Manuals