LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Front Disc Brake Assembly >> Disassembly

Front Disc Brake Assembly: Disassembly

  1. Clean mud and foreign particles from the caliper body assembly and support.
    CAUTION: Be careful not to allow foreign particles to enter inlet (at brake hose connector).
  2. Remove the boot from piston end.
  3. Place a wooden block as shown in Fig 1 to prevent damage to the piston. Gradually supply compressed air via inlet of the brake hose to force piston out.
    Fig 1: Wooden Block Location
    G03751801Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the piston seal from caliper body cylinder.
    CAUTION: Be careful not to scratch the inner surface of cylinder and piston seal groove.
    Fig 2: Removing Piston Seal From Caliper Body Cylinder
    G03751802Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the lock pin boot and guide pin boot.
scientia non olet · About LEMON Manuals