LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Front Brake Pad >> Installation

Front Brake Pad: Installation

  1. Apply thin coat of Molykote AS880N (Part No. 26298AC000) to the frictional portion between pad and pad clip.
  2. Apply thin coat of Molykote AS880N (Part No. 26298AC000) to the frictional portion between pad and pad inner shim.
    CAUTION: Do not allow oil or grease to adhere to the sliding surface of pad and disc rotor.
    Fig 1: Applying Thin Coat Of Molykote AS880N To Frictional Portion Between Pad And Pad Inner Shim
    G03751790Courtesy of SUBARU OF AMERICA, INC.
  3. Check disc rotor thickness and runout.

    < Ref. to , INSPECTION , Front Disc Rotor. >

  4. Install pads on support.
  5. Install caliper body on support.

    Tightening torque: 

    39 N.m (4.0 kgf-m, 28.9 ft-lb) 

    NOTE: If it is difficult to push piston during pad replacement, loosen air bleeder to facilitate work.
  6. Depress brake pedal several times.
  7. Check that brake fluid level is at max. line.
scientia non olet · About LEMON Manuals