Rear Brake Hose

Pass brake hose through the hole of bracket, and lightly tighten flare nut to connect brake pipe.
Insert clamp upward to fix brake hose.
While holding hexagonal part of brake hose fitting with a wrench, tighten flare nut to the specified torque.
Tightening torque (Brake pipe flare nut):

15 N.m (1.5 kgf-m, 10.8 ft-lb)

Fig 1: Installing Rear Brake Hose
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Installing Rear Brake Pipe
Courtesy of SUBARU OF AMERICA, INC.
Bleed air from the brake system.