LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Outback L.L. Bean Edition >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation - Driver Info >> Combination Meter System >> Inspection >> Check Engine Coolant Temperature Sensor

Check Engine Coolant Temperature Sensor

ENGINE COOLANT TEMPERATURE SENSOR CHART

Step Check Yes No
1 CHECK ENGINE COOLANT TEMPERATURE SENSOR. 
Check engine coolant temperature sensor. < Ref. to BASIC DIAGNOSTIC PROCEDURE or BASIC DIAGNOSTIC PROCEDURE or BASIC DIAGNOSTIC PROCEDURE or BASIC DIAGNOSTIC PROCEDURE . >		 Is engine coolant temperature sensor OK? Go to step 2. Replace engine coolant temperature sensor.
2 CHECK HARNESS BETWEEN ENGINE COOLANT TEMPERATURE SENSOR AND COMBINATION METER. 
  1. Turn ignition switch to OFF.
  2. Disconnect connector from engine coolant temperature sensor and combination meter.
  3. Measure resistance between engine coolant temperature sensor harness connector and combination meter harness connector.

    Connector & terminal 

    1. Normal meter: 
    2. (E8) No. 3 - (i12) No. 8: 
 Is the measured value less than 10 ohm? Go to step 3. Repair wiring harness.
3 CHECK WATER TEMPERATURE GAUGE GROUND CIRCUIT. 

Measure resistance between combination meter harness connector terminal and chassis ground.

Connector & terminal 

  1. (i12) No. 9 - Chassis ground: 
 Is the measured value less than 10 ohm? Check water temperature gauge. < Ref. to REMOVAL  . > Repair wiring harness.
scientia non olet · About LEMON Manuals