Steering Roll Connector

Roll Connector

REMOVAL
1. Turn the ignition switch OFF.
2. Disconnect the ground terminal from battery, and wait for at least 20 seconds before starting work.
3. Remove the driver's airbag module.
4. Remove the steering wheel.
5. Remove the steering column cover.




6. Remove the screws, and then remove the roll connector.

INSTALLATION
1. Install the roll connector and steering column cover in the reverse order of removal.
2. Before installing steering wheel, be sure the direction of roll connector is adjusted with steering.

Roll Connector

ADJUSTMENT
1. Check that front wheels are positioned in straight ahead direction.
2. Turn the roll connector pin (A) clockwise until it stops.




3. Turn the roll connector pin (A) counterclockwise approximately 2.65 turns until "A" marks are aligned.





4. Install the steering wheel and airbag module.