Front Oxygen (A/F) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the ground cable from battery.

Fig 1: Disconnecting Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.
Remove the connector from engine hanger, and then disconnect the front oxygen (A/F) sensor connector.

Fig 2: Identifying Engine Hanger
Courtesy of SUBARU OF AMERICA, INC.
Lift-up the vehicle.
Apply SUBARU CRC or its equivalent to the threaded portion of front oxygen (A/F) sensor, and leave it for one minute or more.
SUBARU CRC (Part No. 004301003)
Remove the front oxygen (A/F) sensor.
CAUTION: When Identifying the oxygen (A/F) sensor, wait until exhaust pipe cools, otherwise it will damage exhaust pipe.

Fig 3: Identifying Front Oxygen (A/F) Sensor
Courtesy of SUBARU OF AMERICA, INC.