LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Forester XT, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Disc Brake Assembly >> Installation

Rear Disc Brake Assembly: Installation

  1. Install disc rotor on hub.
  2. Install support on housing. Tighten to specification. See TORQUE SPECIFICATIONS  .
  3. Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
  4. Install pads on support.
  5. Install caliper body on support. Tighten to specification. See TORQUE SPECIFICATIONS  .
  6. Connect brake hose. Tighten to specification. See TORQUE SPECIFICATIONS  .
    CAUTION: The brake hose must be connected without any twist. Replace brake hose gaskets with NEW ones.
  7. Bleed air from brake system. See BLEEDING PROCEDURES  under BLEEDING BRAKE SYSTEM.
scientia non olet · About LEMON Manuals