LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Forester XT, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Hill Holder Pressure Hold Valve >> Installation

Hill Holder Pressure Hold Valve: Installation

  1. Install PHV onto side frame. Tighten to specification. See TORQUE SPECIFICATIONS  .
  2. Connect brake pipes to PHV. Tighten to specification. See TORQUE SPECIFICATIONS  .
    CAUTION: Confirm that brake pipes are not deformed and/or damaged. Replace them with NEW ones if necessary.
  3. Install PHV cable to PHV.
    CAUTION: If cable clamp and clips are damaged, replace them with NEW ones. Avoid sharp bending of PHV cable as it may cause breakage.
  4. Connect PHV cable with clips.
  5. Apply SUNLIGHT 2 (Part No. 003602010) grease to hook portion of return spring and cable end portion of lever.
  6. Bleed air from the brake system. See BLEEDING PROCEDURES  under BLEEDING BRAKE SYSTEM.
  7. Adjust PHV cable. See HILL HOLDER  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals