LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Forester XT, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Disc Brake Pads >> Installation

Front Disc Brake Pads: Installation

  1. Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
  2. Apply a thin coat of Molykote AS880N to the frictional portion between pad and pad inner shim. See Fig 1 .
    CAUTION: Replace pad if there is oil or grease on it. Do not apply grease between outer pad and outer shim. Do not confuse the inner shim with the outer shim.
  3. Check disc rotor thickness and runout. See INSPECTION  under FRONT DISC BRAKE ROTOR.
  4. Install pads on support.
  5. Install caliper body on support. Tighten to specification. See TORQUE SPECIFICATIONS  .
    NOTE: If it is difficult to push the piston during pad replacement, loosen the air bleeder to facilitate work.
  6. Depress brake pedal several times. Check that brake fluid level is at MAX line.
  7. Install front wheel.
Fig 1: Applying Grease Between Pad & Inner Shim
G00305254Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals