Fuel Level Sensor: Removal

WARNING: This page is about a different car, the 2004 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Place "NO FIRE" signs near the working area.
Be careful not to spill fuel on the floor.

NOTE: Fuel level sensor is built in fuel pump assembly.

Remove fuel pump assembly. Refer to FUEL PUMP .
Disconnect connector from fuel pump bracket.

Fig 1: Disconnecting Connector From Fuel Pump
Courtesy of SUBARU OF AMERICA, INC.
Pushing the pawls with a screwdriver, remove fuel meter unit by pulling it downwards.

NOTE: If the retainer pawls are broken during removal, the fuel level sensor must be replaced with a new one.

Fig 2: Removing Fuel Meter Unit

Courtesy of SUBARU OF AMERICA, INC.