LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Baja Base, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Disc Brake Pads >> Installation

Front Disc Brake Pads: Installation

  1. Apply a thin coat of Molykote AS880N (Part No. 26298AC000) to the frictional portion between pad and pad clip.
  2. Apply a thin coat of Molykote AS880N to the frictional portion between pad and pad inner shim. See Fig 1 .
  3. Install pads on support.
  4. Install caliper body on support. Tighten to specification. See TORQUE SPECIFICATIONS  .
    NOTE: If it is difficult to push the piston during pad replacement, loosen the air bleeder to facilitate work.
  5. Install front wheel.
Fig 1: Applying Grease Between Pad & Inner Shim
G00305254Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals