LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Baja Base, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Disc Brake Assembly >> Removal

Front Disc Brake Assembly: Removal

  1. Set vehicle on a lift.
  2. Loosen wheel nuts.
  3. Jack-up vehicle and remove front wheel.
  4. Remove union bolt and disconnect brake hose from caliper body assembly. See Fig 1 .
  5. Remove bolt securing lock pin to caliper body.
  6. Raise caliper body and move it towards the vehicle center to separate it from support.
  7. Remove support from housing. See Figure .
    NOTE: Remove support only when replacing it or the rotor. It does not need to be removed when servicing the caliper body assembly.
  8. Remove disc rotor from hub.
    NOTE: If disc rotor seizes up within the hub, drive the disc rotor out by installing an 8 mm bolt in the 2 holes on the rotor. See Figure .
  9. Clean mud and foreign particles from the caliper body assembly and support.
  10. Check caliper body and piston for uneven wear, damage or rust.
  11. Check rubber parts for deterioration.
  12. Repair or replace faulty parts.
Fig 1: Removing Union Bolt & Lock Pin-To-Caliper Body Bolt
G00275796Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals