LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Baja Base, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior / Interior Trim >> Tail Gate Molding >> Removal

Tail Gate Molding: Removal

  1. Remove tail gate tray. Refer to REMOVAL , Tail Gate Tray.
  2. Remove bolt using TORX(R) bit T25.
    Fig 1: Removing Bolt
    G03510528Courtesy of SUBARU OF AMERICA, INC.
  3. Remove clip and tail gate molding.
    Fig 2: Removing Clip & Tail Gate Molding
    G03510529Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals