LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Outback Limited, 4D Sedan >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Front Disc Brake Assembly >> Disassembly

Front Disc Brake Assembly: Disassembly

  1. Clean mud and foreign particles from the caliper body assembly and support.
    CAUTION: Be careful not to allow foreign particles to enter inlet at brake hose connector.
  2. Remove the boot from the piston end.
  3. Place a wooden block as shown to prevent damage to piston. See Fig 1 . Gradually supply compressed air via caliper body brake hose to force piston out.
  4. Remove the piston seal from the caliper body cylinder. See Fig 2 .
  5. Remove the lock pin boot and guide pin boot.
    NOTE: Repair or replace faulty parts.
  6. Check caliper body and piston for uneven wear, damage or rust.
  7. Check the rubber parts for damage or deterioration.
Fig 1: Forcing Piston Out Using Compressed Air
G00305239Courtesy of SUBARU OF AMERICA, INC.
Fig 2: Removing Piston Seal From Caliper Body Cylinder
G00305281Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals