Sunroof Motor: Installation
CAUTION:
- Never rotate the sunroof motor while removed.
- Be careful not to move the sunroof cable when installing sunroof motor.
- Check the matching mark (A) of sunroof motor.
- Confirm the matching mark (A) of sunroof bracket link.
- Install sunroof motor.
- After installing the motor, reconfirm the matching marks of motor side and sunroof bracket link side.
- Connect sunroof motor harness connector and then connect battery ground cable.
- Check the sunroof operation with the procedure as shown in the table.SUNROOF MOTOR OPERATION AND SWITCH POSITION (SEDAN)
Operation Switch position (1)Completely close sunroof. Closed (2) Tilt-up sunroof to most upper position Tilt-up (3) Lower sunroof completely. Tilt-down (4) Open sunroof to near the completely open position. Open (5) Completely open sunroof. Open (6) Close sunroof 150 mm (5.91 in)away from completely closed position. Closed (7) Completely close sunroof. Closed SUNROOF MOTOR OPERATION AND SWITCH POSITION (WAGON)Operation Switch position (1)Completely close sunroof. Closed (2) Tilt-up sunroof to most upper position Open (3) Lower sunroof completely. Open (4) Open sunroof to near the completely open position. Open (5) Completely open sunroof. Closed (6) Close sunroof 150 mm (5.91 in)away from completely closed position. Closed (7) Completely close sunroof. Closed - Install trims in the reverse order of removal.