Front Bumper: Removal

CAUTION:

Handle bumper carefully to avoid damage to bumper face.
Do not damage body during removal or installation of bumper.
To avoid damage to bumper, lay removed bumper on sheet spread on the floor. Do not lay it directly on the floor.

Open hood.
Disconnect ground cable from battery.
Pull off front side of front mat guard to remove bolts.

Fig 1: Pulling Off Front Side Of Front Mat Guard
Courtesy of SUBARU OF AMERICA, INC.
Remove clip at bottom of bumper.

Fig 2: Removing Clip At Bottom Of Bumper
Courtesy of SUBARU OF AMERICA, INC.
Remove clip (A), and pull out bumper slightly.
Disconnect electrical connector of fog light to remove bumper.

Fig 3: Removing Clip & Pulling Out Bumper
Courtesy of SUBARU OF AMERICA, INC.
Remove E/A FOAM from bumper beam.
CAUTION: E/A FOAM is easy to break. Do not apply excessive force to it during removal.

Fig 4: Removing E/A FOAM From Bumper Beam
Courtesy of SUBARU OF AMERICA, INC.
Remove bumper beam.

Fig 5: Removing Bumper Beam
Courtesy of SUBARU OF AMERICA, INC.