Fuel Level Sensor

REMOVAL

WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
- During work procedures, if fuel tank is more than 3/4 full, be careful because fuel may spill.

NOTE: Fuel level sensor is built in fuel pump assembly.

1. Remove fuel pump assembly.




2. Disconnect connector from fuel pump bracket.




3. Pushing the pawls with a screwdriver, remove fuel meter unit by pulling it downwards.

NOTE: Replace fuel filter pawls with new ones as they might brake when removed.

INSTALLATION




Install in the reverse order of removal.

WARNING:
- Ground cable must be connected.
- Spark may occur and ignite if fuel is nearby.