Stop Light Switch: Inspection

If the stop light switch does not operate properly (or if it does not stop at the specified position), replace with a new one.
1. Specified position:
  1. L: 2 mm (0.079 in)
Fig 1: Checking Stop Light Switch Operates Properly
Courtesy of SUBARU OF AMERICA, INC.
Measure the clearance between threaded end of stop light switch and stopper.
CAUTION: Be careful not to rotate the stop light switch.
1. Stop light switch clearance:
  1. A: 0.3 mm (0.012 in)
Fig 2: Measuring Clearance Between Threaded End Of Stop Light Switch And Stopper
Courtesy of SUBARU OF AMERICA, INC.
If it is not within specified value, adjust it by adjusting the position of stop light switch.
CAUTION: Be careful not to rotate the stop light switch.