Baja, Legacy & Outback 2.5L & 3.0L (2003) & Outback 3.0L (2002)

1. If resistance is felt while rotating, or if abnormal noise is heard, replace the ball bearing.
2. Perform the following;
   1. Remove front bearing retainer.
   2. Closely install a fit tool on the bearing inner race. Press the bearing down out of front cover with a hand press or vise. A socket wrench can serve as the tool. See Fig 1.
   3. Set a new bearing and closely install a fit tool on the bearing outer race. Press the bearing down into place with a hand press or vise. A socket wrench can serve as the tools.
   4. Install front bearing retainer. See Fig 2.

Fig 1: Replacing Front Bearing - Outback 3.0L (2002 - 1 Of 2)

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Replacing Front Bearing - Outback 3.0L (2002 - 2 Of 2)

Courtesy of SUBARU OF AMERICA, INC.