LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Baja Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Rear Disc Brake Assembly >> Disassembly

Rear Disc Brake Assembly: Disassembly

  1. Remove boot ring. See Fig 1 .
  2. Remove piston boot.
  3. Gradually supply compressed air via inlet of caliper body to force piston out.
    CAUTION: Place a wooden block as shown to prevent damage to piston. See Figure . Do not apply excessively high pressure.
  4. Remove piston seal from caliper body cylinder.
  5. Remove lock pin sleeve and boot from caliper body.
  6. Remove guide pin boot.
    NOTE: Repair or replace faulty parts.
  7. Check caliper body and piston for uneven wear, damage or rust.
  8. Check the rubber parts for damage or deterioration.
Fig 1: Removing Rear Disc Brake Boot Ring
G00305246Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals